Ac Power Cord Specifications For An Ex8200 Switch - Juniper EX8208 Hardware Manual

Table 27: Power Specifications for a 3000 W AC Power Supply in an EX8200 Switch
Item
AC input voltage
AC input line frequency
AC input current rating
AC output power

AC Power Cord Specifications for an EX8200 Switch

Each AC power supply has a single AC appliance inlet that requires a dedicated AC power feed. Most sites
distribute power through a main conduit that leads to frame-mounted power distribution panels, one of
which can be located at the top of the rack that houses the switch. An AC power cord connects each
power supply to the power distribution panel.
Each detachable AC power cord is 8 feet (approximately 2.5 meters) long. The appliance coupler end of
the cord inserts into the AC appliance inlet on the faceplate of the AC power supply. The coupler type is
C19 as described by the International Electrotechnical Commission (IEC) standard 60320. The plug end
of the power cord fits into the power source outlet that is standard for your geographical location.
NOTE: In North America, AC power cords must not exceed 15 feet (approximately 4.5 meters)
in length, to comply with National Electrical Code (NEC) Sections 400-8 (NFPA 75, 5-2.2) and
210-52 and Canadian Electrical Code (CEC) Section 4-010(3). The cords shipped with the switch
to North America and Canada are in compliance.
Table 28 on page 67 lists the AC power cord specifications for an EX8200 switch for various countries
and regions.
Specifications
Operating range:
High-voltage line—200–240 VAC
NOTE: Low-voltage line input is not supported for 3000 W AC power
supplies on the EX8216 switch.
50–60 Hz
High-voltage line—16 A
High-voltage line—3000 W
66