Juniper EX8208 Hardware Manual page 297

3. With the screwdriver, loosen the captive screws on each side of the SRE module by turning them
counterclockwise until they are completely unseated.
4. Pull both ejector levers outwards, away from the faceplate of the SRE module, until they go no further.
This action causes the module to slide slightly out of the chassis.
5. Grasp the ejector levers, and pull the SRE module out to about halfway.
6. Place one hand underneath the module to support it, and slide it completely out of the chassis.
7. Locate the coin-shaped CR2032 battery on the right side of the module near the third post (see
Figure 97 on page 297).
8. With your finger, pry the battery out of its socket.
9. If you are recycling the entire chassis of a redundant configuration, repeat Steps 2 through 8 for the
second SRE module.
10. Recycle the battery or batteries as required.
Figure 97: Location of the CR2032 Battery in an SRE Module
Ejector levers Captive screw
CR2032 battery
297