Console Port Connector Pinout Information For An Ex Series Switch; Component Specifications; Table 16: Ex Series Switches Console Port Connector Pinout Information - Juniper EX3300 Complete Hardware Manual

Table 15: Network Port Connector Pinout Information for EX3300 Switches (continued)
Pin
6
7
8
Related
Documentation

Console Port Connector Pinout Information for an EX Series Switch

Table 16: EX Series Switches Console Port Connector Pinout Information

Pin Signal
1 RTS Output
2 DTR Output
3 TxD Output
4 Signal Ground
5 Signal Ground
6 RxD Input
7 CD Input
Copyright © 2015, Juniper Networks, Inc.
Signal
TRP2-
TRP4+
TRP4-
Front Panel of an EX3300 Switch on page 6
Network Port and Uplink Port LEDs in EX3300 Switches on page 17
The console port on an EX Series switch is an RS-232 serial interface that uses an RJ-45
connector to connect to a console management device. The default baud rate for the
console port is 9600 baud.
Table 16 on page 27 provides the pinout information for the RJ-45 console connector.
An RJ-45 cable and an RJ-45 to DB-9 serial port adapter are supplied with the switch.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to an EX Series switch, use a
combination of the RJ-45 to DB-9 female adapter supplied with the switch
and a USB to DB-9 male adapter. You must provide the USB to DB-9 male
adapter.
Description
Request to send
Data terminal ready
Transmit data
Signal ground
Signal ground
Receive data
Data carrier detect
Chapter 3: Component Specifications
Description
Transmit/receive data pair 2
Positive Vport (in PoE models)
Transmit/receive data pair 4
Transmit/receive data pair 4
27