Configuring Junos Os On The Ex8200; Ex8200 Switch Default Configuration - Juniper EX8208 Hardware Manual

Configuring Junos OS on the EX8200

IN THIS SECTION

EX8200 Switch Default Configuration | 193

Connecting and Configuring an EX Series Switch (CLI Procedure) | 194
Connecting and Configuring an EX Series Switch (J-Web Procedure) | 198
Configuring the LCD Panel on EX Series Switches (CLI Procedure) | 202
EX8200 Switch Default Configuration
Each EX8200 switch is programmed with a factory default configuration that contains the values set for
each configuration parameter when a switch is shipped. The default configuration file sets values for
system parameters such as the Address Resolution Protocol (ARP) aging timer, the system log, and file
messages, while also enabling the Link Layer Discovery Protocol (LLDP) protocol, the Rapid Spanning Tree
Protocol (RSTP), Internet Group Management Protocol (IGMP) snooping, and storm control.
When you commit changes to the configuration, a new configuration file is created that becomes the
active configuration. You can always revert to the factory default configuration. See Reverting to the Default
Factory Configuration for the EX Series Switch.
This topic shows the factory default configuration file of an EX8200 switch.
system {
arp {
aging-timer 5;
}
syslog {
user * {
any emergency;
}
file messages {
any notice;
authorization info;
}
file interactive-commands {
interactive-commands any;
193