Installing A Dc Power Supply In An Ex8200 Switch - Juniper EX8208 Hardware Manual

11. Taking care not to touch power supply components, pins, leads, or solder connections, place one hand
under the power supply to support it. Grasp the power supply handle with your other hand and pull
the power supply completely out of the chassis.
12. If you are not replacing the power supply, install the cover panel over the slot, using the Phillips (+)
screwdriver to tighten the screw on the side of the cover panel.
Figure 71: Removing a DC Power Supply from an EX8200 Switch

Installing a DC Power Supply in an EX8200 Switch

The DC power supply in an EX8200 switch is a hot-removable and hot-insertable field-replaceable unit
(FRU). Up to six DC power supplies can be installed in an EX8200 switch. All DC power supplies install in
the front of the chassis in the slots provided at the bottom. See
on page 40 and Slot Numbering for an EX8216 Switch.
NOTE: EX8208 switches support 2000 W DC power supplies.
EX8216 switches support 3000 W DC power supplies.
Before you install a DC power supply in the switch:
"Slot Numbering for an EX8208 Switch"
245