Juniper EX8208 Hardware Manual page 141

The EX8216 chassis ships with the Routing Engine (RE) module(s), SF modules, fan trays, and power supplies
for the configuration you ordered already installed. Any line cards ordered ship separately.
See "EX8208 Switch Configurations" on page 27
base configurations and redundant configurations.
To unpack the switch (see
1. Move the shipping box to a staging area as close to the installation site as possible. For an EX8208
switch, make sure there is enough space to remove components from the chassis if necessary (for
example, if you do not have a mechanical lift to use when you install the switch). While the chassis is
bolted to the pallet, you can use a forklift or pallet jack to move it.
2. Position the shipping box with the arrows pointing up.
3. Open the four pallet fasteners near the bottom of the shipping box that attach the cardboard box to
the wooden pallet. To open a pallet fastener, squeeze together the two ridges ("fins") in the depression
in the latch, then slide the pallet fastener out of the cardboard box slot in which it is inserted. See
Figure 33 on page 141.
Figure 33: Pallet Fastener
4. Carefully slice open the tape that holds the top of the cardboard box closed and open the top of the
box.
5. Remove the cardboard accessory box from the center of the foam padding.
6. Remove the foam padding from the top of the box.
7. Slide the cardboard box off the pallet.
8. Remove the plastic cover from the switch chassis.
and EX8216 Switch Configurations for information about
Figure 34 on page 142 and Figure 35 on page 143):
141