Maintaining The Ex8200 Power Cord Tray - Juniper EX8208 Hardware Manual

10. Push the captive screw into the power supply faceplate. Ensure that the screw is seated inside the
corresponding hole on the faceplate.
11. Tighten the captive screw by turning it clockwise using the Phillips (+) screwdriver, number 1. When
the screw is completely tight, the latch locks into the switch chassis.
To connect power to a DC power supply, see
Figure 72: Installing a DC Power Supply in an EX8200 Switch
SEE ALSO
DC Power Supply in an EX8200 Switch | 70

Maintaining the EX8200 Power Cord Tray

IN THIS SECTION
Removing the Power Cord Tray from a Rack or Cabinet for an EX8200 Switch | 248
Installing the Power Cord Tray in a Rack or Cabinet for an EX8200 Switch | 248
"Connecting DC Power to an EX8200 Switch" on page 174
247