Packing A Line Card Used In An Ex8200 Switch - Juniper EX8208 Hardware Manual

Ensure that the components are adequately protected by wrapping them well with packing materials.
Pack the component in an oversized box (if the original box is not available) with extra packing material
around the unit so that the component is prevented from moving around inside the box.
Securely tape the box closed.
Write the RMA number on the exterior of the box to ensure proper tracking.

Packing a Line Card Used in an EX8200 Switch

If you are returning a line card to Juniper Networks for repair or replacement, pack it as described in this
topic.
Before you begin packing a line card:
Ensure that you have taken the necessary precautions to prevent ESD damage (see
Electrostatic Discharge Damage" on page
Ensure that you know how to handle and store the line card (see Handling and Storing Line Cards in EX6200
and EX8200 Switches).
Retrieve the original shipping carton and packing materials. Contact your JTAC representative if you do
not have these materials, to learn about approved packing materials. See
to Obtain Return Material Authorization" on page
Obtain an antistatic bag.
CAUTION:
component. Place each line card separately in an antistatic bag.
To pack a line card:
1. Place the line card in the antistatic bag.
2. Place the line card in the shipping carton.
3. Place the packing foam on top of and around the line card.
4. Close the top of the cardboard shipping box and seal it with packing tape.
5. Write the RMA number on the exterior of the box to ensure proper tracking.
381).
Do not stack line cards on top of one another or on top of any other
"Contact Customer Support
339.
"Prevention of
344