Powering On An Ex8200 Switch - Juniper EX8208 Hardware Manual

SEE ALSO
DC Power Supply in an EX8200 Switch | 70

Powering On an EX8200 Switch

Before you power on the switch, ensure that:
You have installed all required switch components.
You have installed the required number of power supplies to support redundant operation for the switch
configuration (see "Calculating Power Requirements for an EX8208 Switch" on page 121
Power Requirements for an EX8216 Switch).
You understand how to protect the switch from electrostatic damage (see
Discharge Damage" on page
Ensure that you have the following parts and tools available to power on the switch:
An electrostatic discharge (ESD) grounding strap.
An external management device such as a PC.
A cable to connect the external management device to the primary Switch Fabric and Routing Engine
(SRE) module's console (CON) port or management (MGMT) port in an EX8208 switch or the primary
Routing Engine (RE) module's console (CON) port or management (MGMT) port in an EX8216 switch.
For connecting a management device to the console port, see
Console Using an RJ-45 Connector" on page
port, see "Connect a Device to a Network for Out-of-Band Management" on page
To power on the switch:
1. Attach the ESD grounding strap to your bare wrist and connect the strap to the ESD point on the
chassis.
2. Connect the external management device to the primary SRE or primary RE module's management
(MGMT) port.
3. Turn on the power to the external management device.
4. Ensure that the power supplies are fully inserted in the chassis and that each of their handles is flush
against the faceplate.
5. Ensure that the source power cord is inserted securely into the appliance inlet for each AC power
supply.
381).
183. For connecting a management device to the management
"Prevention of Electrostatic
"Connect a Device to a Management
182.
180
or Calculating