Reinstalling The Printer - Minolta MAGICOLOR 2350 User Manual

2
Place the OPC drum and
transfer belt unit (in their
protective bags) in the
appropriate position in the box
supplied in the repacking kit.
If you return the printer for
service in the Americas, be sure
to also write the RMA (Return
Merchandise Authorization)
number you received from
your customer support
representative on the outside of
the box before shipping the consumables.
3
Securely tape the top flaps of the box closed.

Reinstalling the Printer

If you are shipping the printer to another location, follow steps A–I below to
reinstall the printer once received.
A. Unpack the printer carton.
B. Reinstall the transfer belt unit.
C. Install the OPC drum and return
the transfer belt release lever to its
correct position (7 o'clock).*
D. Install a new waste toner bottle.
E. Replace the toner cartridges.*
F. Install the tray 1 media support
and load the media.
G. Reconnect the power cord and
cables.
H. Install the options.
I. Turn the printer on.
Reinstalling the Printer
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500
Refer to the magicolor 2350
Installation and User's Guides.
See "Reinstalling a Transfer Belt
Unit" on page 176.
Refer to the magicolor 2350
Installation and User's Guides.
*The printer must complete a
150-second calibration cycle after
a consumable has been replaced.
If you open the door before the
message window reads
MAGICOLOR 2350/IDLE
printer stops and repeats the
calibration cycle.
, the
175