Predelivery Checklist - MacDon R113 Unloading And Assembly Instructions

Predelivery Checklist

Perform these checks and adjustments before delivering the machine to your Customer. If adjustments are
required, refer to the appropriate page number in this manual. The completed Checklist should be retained by
either the Operator or the Dealer.
WARNING
Do NOT operate the machine with the driveshields open. High speed rotating components may throw
debris and could result in death or serious injury.
CAUTION
Carefully follow the instructions given. Be alert for safety-related messages that bring your attention to
hazards and unsafe practices.
Serial Number:
Table .11 Rotary Disc Header for Self-Propelled Windrower Predelivery Checklist
✔ ✔ Item
Check for shipping damage or missing parts. Be sure
all shipping dunnage is removed.
Check for loose hardware. Tighten to required torque
if applicable.
Check main drive belt tension.
Check skid shoes are evenly set.
Check side forming shields evenly set to
desired position.
Check rear baffle is about mid-position.
Check conditioner roll gap (roll conditioner).
Check conditioner roll tension (roll conditioner).
Check conditioner roll timing hardware is securely
tightened (roll conditioner).
Check that cutterbar doors are unbolted from centre
channel frame, shipping wire is removed from
cutterbar curtains, and cutterbar curtains are
hanging properly.
Grease all bearings and drivelines.
Check conditioner roll timing gearbox lubricant.
Check cutterbar lubricant.
214075
Reference
9.4 Torque Specifications, page 88
7.1 Checking Conditioner Drive Belt, page 49
7.2 Checking Skid Shoes, page 51
7.10 Checking Forming Shield Deflector Position,
page 64
7.9 Checking Conditioner Baffle Position, page 63
7.7 Checking Roll Gap, page 60
7.3 Checking Roll Timing, page 52
4 Unpacking Curtains, page 41
6.1 Lubrication Procedure, page 48
7.4 Checking and Adding Conditioner Roll Timing
Gearbox Lubricant, page 55
7.6 Checking and Adding Cutterbar Lubricant, page
57
100
—
Revision A