Frx8000 Rlp Parameters - Cabletron Systems Netlink FRX8000 User Manual

FRX8000 RLP Parameters

LP Type
Line Interface Card 1
Line Interface Card 2
RLP Available Memory
6-4
Parameter
LP Type
Line Interface Card 2
RLP Available Memory
Pr otocol 1–5
E1-specific Parameters
Coding
Framing
Line Service
Line Build Out
Clocking
CRC-4 Disabled
Channel Signalling
National Use Bit "n"
International Use bit "n"
An FRX8000 RLP always has 4MB.
1
One protocol on each RLP must be X.25 (type
2
Although pressing displays a range of
[?]
FRX8000 node.
contains physical ports 0–3 for the RLP.
= not installed
0
= RS-232 (used only on N7000 RLPs)
1
= RS-422 (supports RS-449/V.36, RS-530, or X.21 via I/O box and cable)
2
= V.35
3
= High-speed RS-232 (supports RS-232C/V.28 via I/O box and cable)
4
= E1
5
If you replace a Line Interface Card with one of a different type,
any related port records will have some invalid values. Be sure to
change port records as needed.
contain the physical ports 4-7 of the LP. The choices are the same as for Line Interface
Card 1.
is the amount of on-board memory.
Table 6-1 FRX8000 RLP Parameters
Valid Values
7
0–5
4, 8
0–12
3
2
0
6
0 ( Master
N
0
(1–5) Y/N (
1
(0,1) Y/N (
, only
1–7
Default Value
7
4 (
1
(MB)
4
2
0 (
3 (
2 (
0 (
6 (
) , 1 ( Slave 0
)
N
0 (
On/Off N
)
On/Off Y
)
1 ).
( ) is supported in an
7 RLP
FRX8000 3.0 User Guide, Rev 02
HS RS-232
)
none
)
HDB3
)
G.704
)
Full
)
G.703
)
Common
)