Frx8000 Icp - Cabletron Systems Netlink FRX8000 User Manual

Stopping a Switch
Rebooting a Switch

FRX8000 ICP

Starting an ICP
G-2
To shut down a Switch, power the node off.
To reboot a Switch:
1. Press at the FRX8000 Test Menu
[C]
2. When asked: Reboot?
This procedure applies only to an ICP with a VGA monitor. An ICP
without a monitor will boot automatically after it is switched on.
1. Switch on the VGA monitor, then the printer (if present), then the ICP. After a
few seconds, this will be displayed:
SCO System V/386
Boot
:
2. Press . (If any files are corrupted because the system was not shut down
[Enter]
properly, error messages will be displayed. Press
3. You will be prompted:
Type Control-D to proceed with normal startup
(or give root password for system maintenance)
Press (simultaneously)
4. The current system date and time will be displayed. Press
played values, or enter the correct values, in the format:
= year (
YY 00 to 99
= hour (
hh 00 to 23
If you only need to change the time, enter the hour and minute; to change the year,
month, or day, you must enter the entire string, including hour and minute.
5. Various messages will be displayed, ending with:
Type
database (y/n)?
6. scosysv!login: will be displayed. Type
7. When asked for a password, type
8. At the [NETLINK] prompt, type
the FRX8000 Test Menu
(Figure
, press [Y] , and the node will reboot.
.
[Ctrl] [D]
) = month (
MM 01 to 12
) = minute (
mm 00 to 59
.
y [Enter]
netlink [Enter]
mypass [Enter]
start -icp [Enter]
(Figure G-1) will be displayed.
G-1).
if requested to do so.)
[Enter]
to accept the dis-
[Enter]
YYMMDDhhmm
) = day ( )
DD 01 to 31
)
Check protected subsystem
.
.
. The ICP software will start, and
FRX8000 3.0 User Guide, Rev 02
, where: