Cabletron Systems Netlink FRX8000 User Manual page 138

Primary/Secondary Subscriber Name
Primary/Secondary Packet Size
Primary/Secondary Window Size
Creating/Deleting a PVC On Line
9-20
identifies the subscribers to the console operator. The FRX8000 software does not use
this information.
is the size of packets coming from each subscriber device.
is the window size for packets coming from each subscriber device.
You can create a temporary PVC, then delete it later. (Deleting a PVC will break the
connection, but the LCNs will remain dedicated to the PVC until the next IPL of the
nodes at both ends.)
1. Press at the Operations Menu (or
[D]
2. When prompted, enter:
: .
PVC Type 0
Any other requested information, noting the values in
3. When prompted, press
If the operation is successful,
If a "create" fails, you will see:
" ," where:
n
If " " = or
n 1
Either the DLCI requested was invalid or the LP/port was not operational.
If " " = or
n 2
If a "delete" fails, you will see:
If " " = , the local end of PVC does not exist.
n 3
If " " = , the remote node number is incorrect.
n 4
If " " = , the remote LP/port is incorrect.
n 5
When finished with these operations, press any key to return to the
prompt, then press
[F3]
[B], [D]
to create a connection or
[C]
PVC Created/Removed
Can't use same channel
, the request from the local
11
the PVC already exists at the local (
12,
Remove rejected
to return to the Operations Menu.
from the Main Menu).
Table 10-5.
to delete a connection.
[D]
will be displayed.
or
Create rejected
) or remote ( ) end was bad.
(1 11
) or remote (
2
, reason " ," where:
n
Subscriber ID
FRX8000 3.0 User Guide, Rev 02
, reason
) end.
12
: