N7000 Rlp; N7400/7500 Rlp Configuration Record - Cabletron Systems Netlink FRX8000 User Manual

International Use Bit 1

N7000 RLP

6-6
is the setting of bit 1, which is transmitted as the most significant bit of the non-frame
alignment signal when CRC-4 is disabled.
The N7000 (N7400/7500) RLP is supported only in N7400 and N7500
nodes.
The N7000 RLP is nearly identical to the FRX8000 RLP, shown in
To configure an LP record, press
from the Main Menu). When prompted, enter:
[A], [C], [C]
(the node containing the LP):
Node ID
: (default is
LP ID 0–7
(See Table 5-1.)
Any other requested information, noting the values in
at a prompt to specify the default.)
Line Proces sor Main ten ance
* N ode ID
* LP I D
A LP Typ e
B Line I nterface C ard 1:
C Line I nterface C ard 2:
Select:
Figure 6-3 N7400/7500 RLP Configuration Record
at the Line Processor Configuration Menu (or
[C]
1–250
.), as determined by switches 1–3 on the RLP's dipswitch.
0
10
1
6 N74/7500 R LP
1 RS-232
1 RS-232
Figure
. (Default is the "local" node).
Table 5-2. (Press
from Main Menu
[A],[C],[C]
FRX8000 3.0 User Guide, Rev 02
5-1.
[Enter]