Cabletron Systems Netlink FRX8000 User Manual page 264

18-8
5. When prompted, enter the source node ID. (If you are transferring the file from
an NMP, this is the ID of the attached node.)
6. When prompted for a source file name, type
7. When prompted, enter the destination node ID.
8. When prompted for a destination file name, type
9. When notified that the transfer is complete, press
3–6, transferring source file name
10. When the second transfer is complete, press
Network Operations Menu.
Once the
All Software Update
node, the following steps must be done at the remote NMP:
1. Press at the
[R] Main Menu
2. At the prompt, type
[NETLINK]
3. At the next
[NETLINK]
......)
can't access
4. At the next
[NETLINK]
5. When prompted, enter your root password.
6. At the prompt, type:
#
7. At the next prompt, type
#
8. At the next prompt, type
#
9. When asked (after 5-10 minutes):
type .
y [Enter]
10. When asked:
Do you want the kernel environment rebuilt?
11. At the prompt, type
#
12. When asked:
Do you want to continue?
13. When prompted:
Press any key to Reboot
14. At the boot prompt, press
UNIX
15. When prompted to type
press .
[Ctrl] [D]
16. At the login prompt, enter your login name and, if requested, login password.
17. At the prompt, type
[NETLINK]
NMP/rc. once
[Enter]
has been performed for both the remote NMP and its
.
.
stop [Enter]
prompt,
type rc.once [Enter]
prompt, type
su [Enter].
cp pia.o /etc/conf/pack.d/pia/Driver.o [Enter]
cd /etc/conf [Enter]
/etc/conf/bin/idbuild [Enter]
Do you want this kernel to boot by default?
. (
shutdown -g0 [Enter] 0
, type
, press any key.
.
[Enter]
or enter your root password,
Control-D
nmpini [Enter]
.
NMP/pia.o [Enter]
.
pia.o [Enter]
, then , and repeat steps
[Enter] [F]
to destination file name
to return to the
. (Ignore the warnings that say:
.
.
.
, type
y [Enter]
is "zero.")
.
y [Enter]
.
FRX8000 3.0 User Guide, Rev 02
.
rc.once
,
.