Cabletron Systems Netlink FRX8000 User Manual page 224

Creating/Deleting a PVC On Line
14-12
You can create a temporary PVC, then delete it later. (Deleting a PVC will break the
connection, but the X.25 LCN will remain dedicated to the PVC until the next IPL of
the nodes at both ends.)
1. Press at the Operations Menu (or
[D]
2. When prompted, enter:
.
PVC Type: 6
Any other requested information, noting the values in
3. When prompted, press
If the operation is successful,
If a "create" fails, you will see:
" ," where:
n
If " n " = 1 or
Either the channel requested was
If " " = or
n 2
If a "delete" fails, you will see: Remove rejected, reason "
If " " = , local end of PVC does not exist.
n 3
If " " = , remote node number is incorrect.
n 4
If " n " = 5 , remote LP/port is incorrect.
When finished with these operations, press any key to return to the
prompt, then press
[B], [D]
to create a connection or
[C]
PVC Created/Removed
Can't use same channel or Create rejected, reason
11 , the request from the local (
0
, the PVC already exists at the local (
12
[F3] to return to the Operations Menu.
from the Main Menu).
Table 14-3.
to delete a connection.
[D]
will be displayed.
1 ) or remote ( 11
or the LP/port was not operational.
) or remote (
2
," where:
n
FRX8000 3.0 User Guide, Rev 02
) end was bad.
) end.
12
Subscriber ID: