Configuring Network Defaults; Network Defaults File Display - Cabletron Systems Netlink FRX8000 User Manual

Configuring Network Defaults

4-2
The Network Defaults file contains one set of parameters whose values apply to all
FRX8000 and Nucleus 74/7500 nodes in the network. This differs from other database
files, which contain individual records for each component type (nodes, LPs, ports,
etc.). This file also differs from other database files in that you cannot initialize
(described in Chapter 3) the file, or add or delete records.
To configure Network Defaults, press
(Figure 4-1).
Netw ork D efau lts Main ten ance
Cu rrent N ode N umber
Datab ase Master Node
A Network Name
B ELP Page Size
C Outpu t Leading 0s on ELP
D Call Actg Timer (Hrs /10)
E Call Actg Seg. Size
F DN IC
G Line Discnct Timeout (sec)
H Modem Discnct Timeout
I IP N etw ork A ddress
J IPX WAN Network Add ress
1 X.25/X .75 Parameters
2 X.25 D atabase D efau lts
3 Band width Configuration
Select:
Figure 4-2 Network Defaults File Display
Pressing , or displays more parameters, listed in
[1], [2] [3]
X.25 defaults are used to maintain compatibility among nodes; some values
will be overridden by values in the Port file.
Although item 1 is X.25/X.75 Parameters, FRX8000 does not currently
support X.75.
, then from the Network Selection Menu
[A] [C]
10 ABCN ode
10 ABCN ode
"Y our name here"
62
N
0
128
0000
1
0
100.100.100.0
00000001
[A],[A],[A],[C]
Table
FRX8000 3.0 User Guide, Rev 02
from Main Menu
4-1.