Configuring Subscriber Ids; Svc Subscriber Record - Cabletron Systems Netlink FRX8000 User Manual

Configuring Subscriber IDs

When Changes Take Effect
12-8
This operation configures the called and calling addresses that will be used in X.25
call setup if SNA is being transported over the frame relay link via a logical X.25 port.
To complete the connection, the software must recognize where the call is coming
from (calling address) and where it is going (called address).
To configure an SVC Subscriber record, press
uration Menu (or
[A], [F], [A], [C]
, up to 15 digits (as described on
scriber ID
universal wildcard.) If this is an existing record, a screen similar to Figure 12-3 will
be displayed. If this is a new record, enter the remaining requested information, noting
the values in Table 12-2.
Sub scriber Maintenance
* Su bscrib er ID
A Su bscrib er Name
B Dialup Su bscrib er
C Rou tin g A lgorithm
D Sys tematic R ed irection
E Redirect on Bu sy
F Redirect on Out of Order
G Band w. Allocation Grou p
1 Rou tin g Paths
2 Redirection Add ress es
Select:
Figure 12-3 SVC Subscriber Record
The parameters displayed by pressing
When you add a new Subscriber record, the change will be written to the database as
soon as you enter the final parameter value. When you modify a parameter in an
existing record, the change will be written to the database immediately.
The change will become effective to the subscriber as soon as the next call is placed.
(The change will not affect a call in progress.)
, then
[A]
from the Main Menu). When prompted, enter a
page 9-15). (The default is an asterisk, a
10000100001
s sub 1
N
0 Rou nd Robin
Y
N
N
1
[A],[F],[A],[C]
or are listed in
[1] [2]
at the Subscriber Config-
[C]
from Main Menu
Table 12-2.
FRX8000 3.0 User Guide, Rev 02
Sub-