Cabletron Systems Netlink FRX8000 User Manual page 294

[F3] – Environs
[F4] – Operations
[F5] – Next
19-14
depending on what level you are on, displays:
Help
at network level - descriptions of icons
(see
at node level – LP and port status color codes
cursor movement.
at port level – a diagram of the RS-232 line interface, plus color
codes for the connector pins (shown following
(default) returns you to the next higher level in the network
Return
display. (At network level, exits Status Display and returns you to
the Main Menu.)
exits Graphics and returns you to the Main Menu.
Exit
exits this pull-down menu and returns you to the choices at the top
Cancel
of the screen.
Selecting this item displays a pull-down menu whose choices depend on the cursor
location and/or the current network level (i.e., network, subnet, node, LP, port). All
options on this pull-down menu are listed below.
(all except async PAD ports; default for LP.) At port level,
Clear Max Stats
performs the operation; at LP and node levels, displays the
choices: Nodes/LPs/Ports, LPs/Ports, and LPs. Making a
selection sets the appropriate maximum statistic values to
(See
(port only) enables the port.
Enable
(port only) disables the port. (When asked:
Disable
type
(node only) restarts the node.
Re-IPL
backs up the call accounting file. (See
Rollover Acct
(subnet, node; default for subnet) updates the network defaults.
Upd Net Parms
(See Chapter 4.)
is not supported in the current FRX8000 release.
HotNode Status
(all; default for port) leaves this pull-down menu and returns you
Cancel
to the choices at the top of the screen.
Selecting this item (when present) displays the next group of ports.
Table 19-1), and cursor movement.
"Clearing Maximum Statistics
.)
y [Enter]
(Figure 19-9), color codes
(Table 19-1) and
Figure 19-12).
Values" on page 20-8.)
,
Are you sure?
page 18-16.)
FRX8000 3.0 User Guide, Rev 02
.
0