Cabletron Systems Netlink FRX8000 User Manual page 349

Alarms
Action: Note the operation(s) you were performing at the time of this
message, as well as the exact text of the message; then contact
Cabletron Systems Technical
171.
** SHELL Error Function "n" Error "n" from "n:n"
Severity: 1
Meaning: There is a serious problem in the operating system.
Action: Note the operation(s) you were performing at the time of this
message, as well as the exact text of the message; then contact
Cabletron Systems Technical
172.
Node "n" LP "n" Port "n" logical trunk "n" established to Node "n"
Severity: 4
Meaning: Self-explanatory.
173.
Node "n" LP "n" Port "n" logical trunk "n" down – cause "n"
Severity: 3
Meaning: A physical or logical connection that existed between this node, LP/
port/logical trunk and a neighboring node has just become unusable.
A trunk can go down as a result of a break in the physical con-
nection, or because the neighboring node has a problem.
Cause Description
2
4
5
6
Action: None.
174.
Disable on Node "n" LP "n" Datacard "n" Port "n" initiated
Severity: 4
Meaning: Self-explanatory (N74/7500 T1 LPs only).
175.
Enable on Node "n" LP "n" Datacard "n" Port "n" initiated
Severity: 4
Meaning: Self-explanatory (N74/7500 T1 LPs only).
176.
On-line parameter change initiated for Node "n" LP "n" Datacard "n" Port "n"
Severity: 4
Meaning: Self-explanatory (N74/7500 T1 LPs only).
Support. (See page 21-7.)
Support. (See page 21-7.)
Failed (level 1 is down)
Level 2 has dropped, and the trunk process was notified
that the trunk port is no longer operational. This can be
caused by a level 2 link recovery attempting to correct a
line failure.
Trunk was taken down by the routing process because the
remote end did not correctly acknowledge the routing
packets. This usually means that the trunk has stopped
passing data in one direction, so the node that detected the
problem brought the trunk down.
Disabled by operator action (disable port)
21-27