Frx8000 Rlp Configuration Menu - Cabletron Systems Netlink FRX8000 User Manual

When Changes Take Effect
Configuring LPs and LAN Cards
To configure RLP parameters, press
(or from the Main Menu). When prompted, enter:
[A], [C], [C]
(the node containing the LP):
Node ID
(default is
LP ID: 0–7
dipswitch.)
Any other requested information, noting the values in
at a prompt to specify the default.)
Lin e Proces sor Maintenance
* Node I D
* LP ID
LP Type
B Lin e Interface C ard 1:
C Lin e Interface C ard 2:
D RLP Memory in Mgb
E Protocol #1:
F Protocol #2:
G Protocol #3:
H Protocol #4:
I Protocol #5:
3 E1 LIC 2 Parameters
4 E1 LIC 2 Us e Bits:
Select:
Figure 6-2 FRX8000 RLP Configuration Menu
options
E1 3
options will be displayed as menu items
When you add a new LP record, the change will be written to the database as soon as
you enter the final parameter value. When you modify an existing record, the change
will be written to the database immediately.
The change will become effective at the RLP in one of the following ways:
A change to an RLP in an ICP or INM is immediately effective when the
database record is changed.
A change to an RLP in an FRX8000 Switch can be implemented by performing
a
Configuration Update
taining the LP.
, from the Configuration Selection Menu
[C] [C]
1–250.
). This is determined by switches 1–3 on the RLP's
0
10
1
7 RLP
1 RS --232
5 E1
4
1 X.25
3 FRL
4 S DLC
7 IP
11 Trunk
and are displayed only if
4
( from the Main Menu) to the node con-
[B], [B], [D], [A]
(Default is the "local" node).
Table 5-1. (Press
[A],[C],[C] from Main Menu
is . If is
LIC2 E1 LIC1 E1
and .
1 2
[Enter]
, similar
6-3