Cabletron Systems Netlink FRX8000 User Manual page 366

21-44
364.
Node "n" LP "n" Port "n" DLCI "n" Frame Relay PVC Disconnected from
Node "n" LP "n" Port "n" DLCI "n"
Severity: 3
Meaning: Self-explanatory.
365.
Node "n" LP "n" Port "n" DLCI "n" Received bad frame
Severity: 3
Meaning: Either the DLCI was not configured or the frame was on an
unavailable DLCI.
Action: Configure the DLCI or re-send the frame.
366.
Node "n" LP "n" Port "n" Entering LMI/AnnexD Service Affecting Condition
Severity: 2
Meaning: The DTE and DCE exchange messages regularly so that each
knows the other is running and ready. If one end does not respond,
this alarm message is sent and the link goes down.
Action: Check the equipment to see what caused the failure to respond.
367.
Node "n" LP "n" Port "n" DLCI "n" Flow control on
Severity: 3
Meaning: Flow control has been implemented and data is queued.
Action: None.
368.
Node "n" LP "n" Port "n" DLCI "n" Frame discarded–congestion
Severity: 3
Meaning: Self-explanatory.
Action: The frame must be resent.
369.
Node "n" LP "n" Port "n" DLCI "n" Line does not exist or is not a FRMREL Port
Severity: 3
Meaning: Self-explanatory. ("
Action: Check the configuration records for the node, LP, and port, and
create records where necessary
370.
FR LP "n" Port "n" DLCI "n" not active
Severity: 3
Meaning: The specified DLCI has not been configured on the port.
Action: Configure the DLCI in the port record
371.
FR LP "n" Port "n" frame relay header invalid "n"
Severity: 3
Meaning: The header contained an invalid DLCI.
" is frame relay.)
FRMREL
FRX8000 3.0 User Guide, Rev 02