Cabletron Systems Netlink FRX8000 User Manual page 123

Physical Interface
Blocked Port Flag
Configuring X.25
Parameter
DTE Restar t Retry Count
DTE Reset Retry Count
DTE Clear Retry Countt
6
Line Setup Retr ies
6
Modem INI Name
Prefer ential CUG Flag
Prefer ential CUG Index
Outgoing Access Allowed
Incoming Access Allowed
Group Send Allowed
Mapped DLCI Num ber
Connection Priority
Encapsulation Method
Bandwidth Allocation Group
One higher than
1
Default Low SVC LCN
for AST LP not configured for
512
2
Default Packet Size in Network Defaults, or
3
is greater than
512
FRX8000 Switch ports only.
4
Default Window Size
5
N7000 V.25bis ports only.
6
The connection defined by the card, port, and DLCI must be different for each logical
7
connection (logical port, IP/IPX interface over frame relay) in this node.
This parameter is displayed only if
8
Specifying means that the DLCI is not assigned to a bandwidth allocation group.
0
9
should be specified for Bandwidth Allocation Group only if
0
specified for all connections on the same DLCI; otherwise, allo-
cation will be unpredictable between assigned and unassigned
traffic.
is the hardware interface. On an AST LP port, this is always RS-232. On an RLP port,
the interface is determined by the associated Line Interface Card (LIC) and the cable
attached to the port's I/O box connector. The LP record identifies the LIC, and only
the valid interfaces will be displayed as choices in the Port record. LICs are shown in
parentheses:
= RS-232 (RS-232)
3
= RS-449 (RS-422)
6
causes the port to be enabled (
that state until this parameter is changed (and sent to the node) or an on-line enable/
disable is performed. (See
Table 9-1 X.25 Port Parameters
Valid Values
4
0–99
4
0–99
4
0–99
0–99
up to 10 characters
Y/N
0–99
Y/N
Y/N
(N7000 only)
Y/N
16–991
0–9
0–1
8
0–16
Highest Incoming Channel
in the Network Defaults file.
Big Packet Supported
and LP is not configured for
in Network Defaults file.
Encapsulation Method
= V.25Bis_Dial (RS-232)
4
= RS-530 (RS-422)
7
) or disabled (
N Y
Disabling and Enabling Ports
(contd.)
Default Value
0
0
0
5
none
N
0
N
N
N
7
none
0
(RFC1490)
0
9
1
. If that is not used, the value will be the
.
if AST LP and Network Defaults value
512
.
Big Packet Supported
is .
0
= V.35 (V.35)
5
= X.21 (RS-422)
8
) at node IPL. The port will remain in
on page 18-1.)
is
0
9-5