Cabletron Systems Netlink FRX8000 User Manual page 102

Creating/Deleting a PVC On Line
7-22
You can create a temporary PVC, then delete it later. (Deleting a PVC will break the
connection, but the LCN will remain dedicated to the PVC until the next IPL of the
node.)
1. Press at the Operations Menu (or
[D]
2. When prompted, enter:
:
PVC Type 7
Any other requested information, noting the values in
3. When prompted, press
If the operation is successful,
If a "create" fails, you will see:
where:
If " n " = 1 or 11 , the request from the logical (
Either the channel requested was
If " " = or , the PVC already exists at the logical (
n 2 12
If a "delete" fails, you will see:
If " n " = 3 , logical port does not exist.
If " " = , node number is incorrect.
n 4
If " " = , LP/port is incorrect.
n 5
When finished with these operations, press any key to return to the
prompt, then press
[F3]
[B], [D]
.
to create a connection or
[C]
PVC Created/Removed
Can't use same channel
or the LP/port was not operational.
0
Remove rejected, reason "n,"
to return to the Operations Menu.
from the Main Menu).
Table
to delete a connection.
[D]
will be displayed.
or
Create rejected, reason "n,"
1 ) or physical ( 11 ) end was bad.
) or physical (
2
where:
Subscriber ID:
FRX8000 3.0 User Guide, Rev 02
7-5.
) end.
12