Cabletron Systems Netlink FRX8000 User Manual page 29

Introduction to Database Configuration
E Configure LAN Interfaces
A Configure IP Interfaces
in FRX8000s on the network. Identifies type (X.25, Ethernet, etc.) and
operating parameters. Required for every IP interface.
B Configure IPX Management
A Configure IPX Interface
interfaces in FRX8000s on the network. Identifies type (X.25,
Ethernet, etc.) and operating parameters. Required for every IPX
interface.
B Configure IPX Applications
filter types, and/or directions.
C SNA LLC2 Management
A Configure SNA LLC2 Hosts
type (originated or terminated), necessary addresses, timers.
B Configure SNA LLC2 Interface
of any LLC2 interfaces.
F Configure Connections and Routing Paths
A Configure Subscriber
of subscriber IDs, used as called and calling addresses in X.25 call setup;
algorithms for call routing; bandwidth allocation, redirection addresses.
Required for all traffic being transported over a logical X.25 port.
B Configure Abbreviated Address
mnemonic that can be substituted for an async PAD subscriber address.
C Configure PVC Connection
Chapter 9 (X.25), Chapter 13 (async), Chapter 14 (IP). Creation of
"permanent" connections between FRX8000 ports. Identifies location,
protocols at each end, operating parameters.
D Configure IP Route
E Configure IPX Route
traffic.
F Configure Group Name
Group Send messages.
G Configure Group Send
broadcast a message to a group of subscribers by sending a single Call
Request.
H Configure Telephone Number
Numbers used by all V.25bis modems on the network.
I Configure T1/E1 Channel Map
T1/E1 lines. Required for all T1/E1 cards.
G Configuration Report
for one or all FRX8000s on the network, listing database parameters and
values.
H Change Passwords
used to access FRX8000 operations.
– Chapter 14. Identification of any IP interfaces
– Chapter 15.
– identification of any Novell
– applies IPX filters to interfaces,
– Chapter 11.
– defines LLC2 hosts; includes session
– specifies location, type, and format
– Chapter 9 and misc. other chapters. Specification
– Chapter 13. Creates a short name or
– Chapter 7 (trunk), Chapter 8
– Chapter 14. Creation of fixed routes for IP traffic.
– Chapter 15. Creation of fixed routes for IPX
– Chapter 9. Specifies a name to be used for
– Chapter 9. Allows an X.25 subscriber to
– Chapter 7 (trunk), Chapter 9 (X.25).
– Chapter
– page 3-12. Produces a summary of database records
– Appendix C. Allows changing several of the passwords
IPX
®
(frame
6. DS0 channel assignments for
relay),
3-3