Configuring Subscriber Ids; Svc Subscriber Record - Cabletron Systems Netlink FRX8000 User Manual

LPDA Support
Idle Fill Character

Configuring Subscriber IDs

Configuring SNA
specifies the version (if any) of Link Problem Determination Aid that can be used by
a host program (e.g., VTAM) or controller program (e.g., NCP) to test status and to
control the line and remote interface.
Configurable values are:
specifies a character that will be inserted into the stream when the SNA link is idle.
This operation configures the called and calling addresses that will be used in X.25
call setup if SNA is being transported over the frame relay link via a logical X.25 port.
To complete the connection, the software must recognize where the call is coming
from (calling address) and where it is going (called address).
To configure an SVC Subscriber record, press
uration Menu (or
[A], [F], [A], [C]
, up to 15 digits (as described on
scriber ID
which is a universal wildcard.) If this is an existing record, a screen similar to Figure
11-4 will be displayed. If this is a new record, enter the remaining requested infor-
mation, noting the values in
Su bscrib er Maintenance
* S ubs criber ID
A S ubs criber Name
B D ialup Su bscrib er
C R outing A lgorithm
D S ystematic R ed irection
E R ed irect on Busy
F R ed irect on Ou t of Order
G Ban dw. A llocation Grou p
1 R outing Paths
2 R ed irection Add ress es
Select:
Figure 11-4 SVC Subscriber Record
The parameters displayed by pressing
= None = Version 1
0 1
[A]
from the Main Menu). When prompted, enter a
page 9-15). (The default is an asterisk,
Table 11-5.
10000100001
ssu b1
N
0 R ound Rob in
Y
N
N
1
or are listed in Table 11-5.
[1] [2]
= Version 2
2
, then at the Subscriber Config-
[C]
from Main Menu
[A],[F],[A],[C]
Sub-
11-9