Alarms Report - Cabletron Systems Netlink FRX8000 User Manual

Displaying Alarms
Alarms
The format for all four options is the same. Table 21-1 shows a sample display.
The content of the report is described under
Although printed and displayed reports are structured differently, the information
is the same.
Alarms Report from Node 8
For N ode(s): 7
Node Alarm
7 224S
7 194
7 194
7 194
7 194
7 194
7 194
7 194
7 194
7 194
7 194
Alarms can be displayed in two operations. One is accessed in graphics mode, and is
described under Graphics-level Status Displays
from the menu level, and is described here.
To redirect alarm reporting from the printer to the console, press
Menu (or [D], [C] from the Main Menu). The following message appears:
Console is Reserved for Event Log -- Hit F3 to Return to Normal Mode
When an alarm occurs, it will now be displayed on your screen, in the same format as
the report (see Figure 21-1), except that the header information and node number are
not shown.
As long as the redirection is in effect, your screen is dedicated to real-time reporting
of alarm messages. Then press
sending alarm messages to the printer. Press any key to return to the Alarms Menu.
Time 96/5/10 13:59:58
Alarm Level: ALL From: 000101 000000
Date Time Descrip tion
980110 113231 Nod e 7, LP 2 Port 0 trunk established to N ode 8
980110 113225 LP 1 Port 6 enabled
980110 113225 LP 1 Port 5 enabled
980110 113225 LP 1 Port 4 enabled
980110 113225 LP 1 Port 3 enabled
980110 113221 LP 1 Port 2 enabled
980110 113218 LP 1 Port 1 enabled
980110 113214 LP 1 Port 0 enabled
980110 113210 LP 0 Port 2 enabled
980110 113205 LP 0 Port 1 enabled
980110 113200 LP 0 Port 0 enabled
Figure 21-1 Alarms Report
to return the screen to normal mode and resume
[F3]
"Message Format" on page 21-6.
To: 991231 235959
on page 19-10; the other is accessed
at the Alarms
[C]
21-3