Configuring A Static Ipx Route; Ipx Rip Route Record - Cabletron Systems Netlink FRX8000 User Manual

Configuring a Static IPX Route

When Changes Take Effect
15-18
Routing of IPX traffic is handled dynamically by such protocols as RIP and SAP, as
well as via static routes configured in the FRX8000. To configure a static route, press
then from the Connections and Routing Paths Selection Menu (or
[E], [C]
from the Main Menu). When prompted, enter:
[C]
: (RIP) or
Type 0
. (Default is the local node.
Node: 1–250
. (The default is
Route: 0–65535
Any other requested information, noting
The display will be similar to the RIP example in the following figure. (A SAP record
will display different parameters.)
IPX Route Maintenance
* Type
* Nod e
* Rou te Nu mber
A Network Ad dres s
B Hops
C Transp ort Time
D Rou ter
E In terface
Select:
Figure 15-4 IPX RIP Route Record
When you add a new IPX Route record, the change will be written to the database as
soon as you enter the final parameter value. When you modify a parameter in an
existing record, the change will be written to the database instantly.
To make the change effective, press
done, the change will become effective the next time the node containing the interface
undergoes re-IPL.
(SAP). (The default is
1
.). This is simply an identifier.
0
0 RIP
10
23
0000f0ac
26
30
00000000ff34
5
while the record is displayed. (If this isn't
[F7]
.)
0
Table 15-10.
[A],[F],[E],[C]
from Main Menu
FRX8000 3.0 User Guide, Rev 02
[A], [F], [E],