Cabletron Systems Netlink FRX8000 User Manual page 330

21-8
7.
Type "n" LP "n" in database but does not exist
Severity: 3
Meaning: The LP has a record in the database, but the hardware is not recog-
nized.
Action: Make sure the LP is installed. If already installed, it may be bad;
replace it and re-IPL the node.
8.
PPM "n" Type 1 in database but does not exist
Severity: 3
Meaning: The PPM is not recognized.
Action: There is a failure in the node that must be repaired. Contact
Cabletron Systems Technical
9.
LP "n" has been loaded
Severity: 4
Meaning: The Load Image file has been loaded to the LP during node IPL.
10.
PPM 1 has been loaded
Severity: 4
Meaning: The Load Image file has been loaded into the processor during node
IPL.
11.
Bad Load Image File – Error "n"
Severity: 3
Meaning: The Load task has discovered format errors in the Load Image file.
Possible error numbers are:
The colon at the beginning of the record is missing, so the
1
record was discarded.
The record is longer than specified in the record count, so
2
the remainder of the record was ignored.
Action: Try to re-IPL the node. If it fails to IPL, contact
Technical
13.
LP "n" exists but is not in database
Severity: 3
Meaning: The packet processing system has found an LP that has no record in
the database.
Action: Create an LP record for this LP, then implement the change at the
node by one of the methods described in under "When Changes
Take Effect"on page 6-3.
Support. (See page 21-7.)
Support. (See page 21-7.)
Cabletron Systems
FRX8000 3.0 User Guide, Rev 02