Configuring Subscriber Ids - Cabletron Systems Netlink FRX8000 User Manual

Logical Port Parameters
Underlying Physical Port
Blocked Flag
Calling Address
Called Address

Configuring Subscriber IDs

Configuring Inter-Nodal Trunks
is the physical PDN port (whose record must be configured first) on which this logical
port is being configured.
causes the logical port to be enabled (
remain in that state until this parameter is changed (and sent to the node) or an on-line
enable/disable is performed. (See
identifies the local end of the logical trunk. This address does not need to be con-
figured in the Subscriber file, but it must be unique among addresses configured in the
database.
identifies the remote end of the logical trunk. This address does not need to be con-
figured in the Subscriber file, but it must be unique among addresses configured in the
database.
This operation creates records for the called and calling addresses that will be used in
call setup on logical trunks. To complete the connection, the software must recognize
where the call is coming from (calling address) and where it is going (called address).
To configure an SVC Subscriber record, press
uration Menu (or
[A], [F], [A], [C]
of up to 15 digits. (The default is an asterisk, which is a universal
Subscriber ID
wildcard.)
Subscriber addressing
If this is an existing record, a screen similar to
a new record, enter the remaining requested information, noting the values in
Table 7-4.
) or disabled ( ) at node IPL. The port will
N Y
"Disabling and Enabling Ports"
, then
[A]
from the Main Menu). When prompted, enter a
is described on page 9-15.
Figure 7-7
on page 18-1.)
at the Subscriber Config-
[C]
will be displayed. If this is
7-17