Configuring Snmp Parameters; Snmp System Defaults Menu - Cabletron Systems Netlink FRX8000 User Manual

Configuring SNMP Parameters

System Defaults
16-2
To configure SNMP parameters for the FRX8000 node, press
Node Selection Menu (or
enter:
Node number: 1–250
:
Parameter Type
Any other requested information, as described in the following paragraphs.
System defaults are entries that will be included in IPL messages to the SNMP agent,
and will be stored for access via the MIB. Changes to these parameters can be made
either in this record or through the SNMP agent.
If was selected for
1 Parameter Type
if you want to specify a System Name.
1
if you want to specify a System Contact.
2
3 if you want to specify a System Location.
S NMP Parameters Maintenan ce
Node I D
SNMP Parameter Type
Ind ex
A System N ame
S elect:
Figure 16-1 SNMP System Defaults Menu
Item
A
from the Main Menu). When prompted,
[A], [B], [B], [C]
.
= SNMP System Defaults
1
= Community Parameters
2
= Trap Parameters
3
= Model (hardware chassis)
4
, enter (when prompted) an index number:
100
1 S ystem Parameters
1 S ystem N ame
ABC DE
will be different if or
2
, then
[B]
[A],[B],[B],[C] from Main Menu
was selected for
3 Index
FRX8000 3.0 User Guide, Rev 02
from the
[C]
.