Table of Contents
Advertisement
Cancelling an Immediate Transmission
• If you haven't pressed the Start key yet, press the Clear Modes/Energy
Saver key. If you have set the original, removing it will also cancel Imme-
diate Transmission.
• If you have pressed the Start key and the machine is dialing or transmit-
ting, press the Clear/Stop key and remove the original. Some pages may
have already been sent.
If the destination could not be connected to
If it was not possible to make a
connection with the number you
dialed (for example if the line was
busy or there is a line problem), the
display opposite appears:
• If you press [Memory Trans.], the machine will scan all the originals into
memory. When finished, it will begin redialing the destination and, if pos-
sible, send the message from memory.
• If you press [Cancel] then [OK] the transmission will be canceled.
ECM (Error Correction Mode)
This feature automatically resends data that wasn't transmitted success-
fully using a system that complies with international standards. ECM re-
quires that the destination machine has the same feature.
Hint
By default, ECM is on. You can change this with User Parameters (see page 203).
If you turn this report on, a report will be printed after every Immediate Trans-
mission so you have a record of whether the transmission was successful or
not. If the machine is set up not to print this report and the fax message could
not be successfully transmitted. The Error report is printed.
Hint
By default this report is turned off. Switch it on with the User Parameters (see
page 203).
If the page was sent successfully, the page column gives the total number of
page that were sent successfully.
If the page was not sent, the page column gives the page number of the page
that was not sent.
36
Advertisement
Table of Contents
