Table of Contents
Advertisement
If the receiver uses paper narrower than the original, the image will be reduced to
fit the paper width.
If an original larger than the above maximum scanning area, do one of the follow-
ing.
· Change the user parameter (see page 203)
· Specify the irregular scan area (see page 160)
The machine detects paper sizes in the following ways:.
When you set an original in the ADF/ARDF, an original wider than about 190 mm is
scanned as A4 size wide. An original narrower than about 265 mm is scanned as B4
size wide. An original wider than about 265 mm is scanned as A3 size. Originals
narrower than 190 mm will be sent as A4 size. Originals up to 1200 mm in length can
be scanned. Widths between 227 and 228 mm cannot be identified correctly as
widths of A4 or B4 size.
When you set an original on the exposure glass, an original wider than about 70 mm
is scanned as A4 size wide. An original narrower than about 261 mm is scanned as
B4 size wide. Originals wider than 262 mm are scanned as A3 size. Originals nar-
rower than 70 mm will be sent as A4 size. Normally, lengths up to a maximum of 420
mm can be scanned (this figure varies slightly depending on the type of original). If
you select Irregular Scan Area, lengths up to 432 mm are possible. If the width is
between 237 to 249 mm, the machine cannot detect the size correctly.
1. The maximum scan area for Memory Transmission is 297 mm × 432 mm (A3), 11"
× 17" (DLT).
2. Single-Sided immediate transmission from the ADF/ARDF, check the table below.
20
Advertisement
Table of Contents
