Table of Contents
Advertisement
Automatic Redial
If a fax message could not be transmitted because the line was busy or an
error occured during transmission, redialing is done 4 times at 5 minutes
intervals (these figures vary according to which country you are in).
If redialing fails after four redials, the machine cancels the transmission and
prints the Transmission Result Report (see page 33) or the Communication
Failure Report (see page 33).
Broadcasting Sequence
If you dial several destinations for the same message (Broadcasting) the
messages are sent in the order in which they were dialed. If the fax mes-
sage could not be transmitted, the machine Redials that destination after
the last destination specified for Broadcasting. For example, if you specify
four destinations A through D for broadcasting, and if the lines to the desti-
nations A and C are busy, the machine dials the destinations in the follow-
ing order: A, B, C, D, A, and C.
Broadcasting: checking the progress
To check up to which destination the fax message has been sent during
Broadcasting, print the TX file list (see page 111).
If memory runs out while storing an original
If you wish to send only scanned pages and you run out of memory while
storing an original (free space reaches 0%), "Memory full" is displayed.
Press [OK] to return to the previous display.
Hint
By default, successfully scanned pages are sent. If you wish to change this setting,
please contact your service representative.
Batch Transmission
If you send a fax message by Memory Transmission and there is another
fax message waiting in memory to be sent to the same destination, that
message is sent along with your original. Several fax messages can be
sent with a single call eliminating the need for several separate calls. This
helps save communication costs and reduce transmission time.
Fax messages for which the transmission time has been set in advance are
sent by batch transmission when that time is reached.
Hint
By default Batch Transmission is switched on. You can switch it on or off with the
User Parameters (page 203).
31
Advertisement
Table of Contents
