Table of Contents
Advertisement
When a registered group is being used for a standby Memory Transmission, the
message "This destination is in use for standby transmission file. Please modify/
delete after transmission" is shown and you cannot change destinations for this
Group.
1 Follow steps
2 Enter the function number for "Register/Delete" using the Number keys.
3 Enter the function number for
"Reg. Group Dial" using the Num-
ber keys.
4 Press the Quick Dial key in which
you want to register the Group.
Hint
If you make a mistake, press [Can-
cel] then the correct key.
You can press [Status] to see the
which Quick Dial keys are currently
programmed.
5 Enter the first fax number then
press [Add] before you enter the
next.
Hint
Enter a destination in any of the following three ways:
• Enter the fax number using the Number keys.
• Press a Quick Dial key in which the destination is registered.
• Press the Speed Dial key and enter a Speed Dial code.
If you make a mistake, press the Clear/Stop key and re-enter the correct Group
number.
If destinations are already registered, they are shown on the display. Press the
or
key to scroll through the destinations on the display. If you want to change
a destination, select it and press the Clear/Stop key. Press the Clear/Stop key
once to erase a Quick Dial or Speed Dial number, or press it repeatedly to erase
a number entered with the Number keys.
When you specify the destination using the number keys, they will be erased one
by one.
When using Quick dial or Speed dial, they will be erased at once.
You cannot omit a fax number.
142
to
shown in "Accessing the User Tools" (page 136).
Advertisement
Table of Contents
