Table of Contents
Advertisement
IMPORTANT
It is recommended that you print the User Parameter list and keep it when
you register or change a user parameter. ⇒ See page 203.
Do not change bits other than those shown on the previous pages.
1 Follow steps to shown in "Changing the User Tool Settings" (page 136).
2 Enter the function number for "Key Op. Settings" using the Number keys
and press the Enter (#) key within 3 seconds.
3 Enter the function number for
"User Parameters" using the Num-
ber keys.
4 Select a number for a switch you
wish to change by pressing
[↑Switch] and [↓Switch].
5 Press a number key corres ponding to the bit number you wish to change,
e, g, Press "0" to change bit 0.
6 When you have finished, press [OK].
Hint
If you press [Cancel], the specified settings are canceled and the display shown
in 3 appears again.
206
Advertisement
Table of Contents
