Table of Contents
Advertisement
Hint
To register a sender, use an RTI or CSI. When you communicate with a sender
using G4, register G4TID.
You can see an RTI or CSI of a sender in the destination name column of the
journal (page 123).
Before using the Special RX Nos. function, switch this function to On by following
the steps shown in "Initial Setup RX" (page 166).
1 Follow steps to shown in "Changing the User Tool Settings" (page 136).
2 Enter the function number for Key Op. Settings using the Number keys and
press the Enter(#) key within 3 seconds.
3 Enter the function number for "Spe-
cial RX Nos". using the Number
keys.
4 Enter the function number for
"Register Sender" using the Num-
ber keys.
5 Choose a number where you want
to program a Specific Sender.
Hint
If you make a mistake, press the Clear/Stop key and reenter a correct value. If you
enter a wrong value for the second digit, press [Cancel] and enter it again.
6 Press [RTI/CSI].
184
Advertisement
Table of Contents
