Table of Contents
Advertisement
Hint
You cannot enter the numbers of the End Receivers directly. The numbers must be
stored in Quick Dials, Speed Dials or Groups in the Transfer Station(s). To specify
an End Receiver, use the special format described on page 104.
Press [Add RcvStn] if you wish enter more End Receivers.
Press
or
to see the End Receivers already entered. You can select an End
Receiver from this list and cancel it by pressing the Clear/Stop key.
To cancel the Transfer Request, press [Cancel].
When you have specified all the
End Receivers, press [OK].
If you want to enter an additional
Transfer Station, press [Yes] and
repeat steps 4 to 6.
If you press [No], the Transmis-
sion Mode menu is shown and
a check mark is added to Trans-
fer Request.
Press [Exit].
The initial display is shown.
Hint
The numbers of Transfer Stations and End Receivers are displayed.
Press the Start key.
103
Advertisement
Table of Contents
