Table of Contents
Advertisement
3. When sending from the exposure glass, the maximum scan area is 11" × 17"(DLT)
297 mm × 432 (A3) mm.
If the machine cannot detect the original size, the following display is shown:
Remove the original and replace it on the exposure glass. Press the Start
key to scan the original again. If the machine still cannot detect the original
size, the following display is shown:
Press the
and
again.
In this manual an original can mean a single or multiple page document.
You can set your originals either in the ADF (Auto Document Feeder),
ARDF(Auto Reverse Document Feeder) or on the exposure glass. Some
types of orignals are unsuitable for the ADF so they must be set on the expo-
sure glass (see "Acceptable Types of Originals" on page 18).
Which way you place your original depends on its size and whether you are
using the ADF/ARDF or the exposure glass. Check the diagrams below.
Hint
When sending a fax, the image output at the other end depends on the size and
direction of paper used in the receiver's terminal. If the receiver does not use
paper of the same size and direction as that of the original, the fax image may be
output reduced, trimmed at the both edges, or divided into two or more sheets.
When sending an important original, we recommend you to ask the receiver about
the size and direction of the paper used in their terminal.
When sending an original of a irregular (non-standard) size or part of a large
original, you can specify the scan area precisely (see "Specifying an Irregular
Scan Area" on page 160).
keys to switch the scan size and press the Start key
21
Advertisement
Table of Contents
