KYOWA WGA-910A Series Instruction Manual page 9

SD cards
The capacity of the SDHC card, applicable to the product, is up to 32 GB.
The product does not support the SDXC cards 64 GB or more.
Never insert the SDXC cards 64 GB or more.
PRECAUTIONS ON CE MARKING
NOTE
Be sure to mount the product on the control panel, etc. Before turning ON the power, make sure the
product is covered to avoid contact with hands.
The product connection should be executed by experts in electrical work.
To immediately turn OFF the product, place switches or circuit breakers inside the building and near the
product and display the functions as well.
Use switches and circuit breakers conforming to the IEC60947-1 and IEC60947-3.
Use the product in area where elevation is 2000 m or below.
When mounting the product in your system, approaches to satisfy the CE marking requirements vary
with the configuration of the control panel to be used, the other devices to be connected, and wirings.
Therefore, customers are required to check whether the CE marking requirements on the product are
satisfied or not.
Use shielded cables as input cables, output cables and control cables.
Wiring should be 30 m or less.
Before connecting the analog monitor and RS-232C communication cables, be sure to mount ferrite core
near the terminal.
Recommended ferrite core
Be sure to connect the protective grounding terminal to the ground by using the optional ground wire.
CAUTION
GRFC-5 (KITAGAWA INDUSTRIES CO., LTD.)
5