KYOWA WGA-910A Series Instruction Manual page 65

Switching the measurement conditions with the control input.
For the "Control Input" on the "Meas. Select Signal" window only.
Switch the ON/OFF of the control input's "Measurement condition select 0 to 3" as the following table.
Measuring
Condition
No.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
6-3-2. Comparison Setting
Compares a measured value with a compared value, and puts out the result.
The comparison result is obtained from the control I/O connector as an open collector output.
In addition, colors of the comparator status lamps on the "Measuring" window change.
Capable of preventing chattering or erroneous operations of comparator outputs by setting hysteresis (non-sensitive
zone) within a compared value.
(1) HH compared value, HI compared value, LO compared value, LL compared value
<Setting Range>
-99999 to 99999 (count)
<Operations from the setting window>
1) Set the No. of the Measuring Condition on the "Meas. Cond.
Setting" window.
2) Press the
window.
3) Press any of the
4) Input a setting value with the numeric keyboard and press the
key to register the setting value.
Measurement
Condition Select 0
OFF(open)
ON(close)
OFF(open)
ON(close)
OFF(open)
ON(close)
OFF(open)
ON(close)
OFF(open)
ON(close)
OFF(open)
ON(close)
OFF(open)
ON(close)
OFF(open)
ON(close)
key on the "Meas. Cond. Setting"
key on the "Comparison Setting (1/2)" window.
Measurement Measurement
Condition Select 1 Condition Select 2
OFF(open)
OFF(open)
ON(close)
ON(close)
OFF(open)
OFF(open)
ON(close)
ON(close)
OFF(open)
OFF(open)
ON(close)
ON(close)
OFF(open)
OFF(open)
ON(close)
ON(close)
61
Measurement
Condition Select 3
OFF(open) OFF(open)
OFF(open) OFF(open)
OFF(open) OFF(open)
OFF(open) OFF(open)
ON(close) OFF(open)
ON(close) OFF(open)
ON(close) OFF(open)
ON(close) OFF(open)
OFF(open) ON(close)
OFF(open) ON(close)
OFF(open) ON(close)
OFF(open) ON(close)
ON(close) ON(close)
ON(close) ON(close)
ON(close) ON(close)
ON(close) ON(close)