KYOWA WGA-910A Series Instruction Manual page 73

(5) Display Mode
Selects the display operation of the peak (bottom) value from the two modes.
Sets the target Display Mode. For the "Block-specified Peak", "Block-specified Bottom", "Time-specified Peak ",
"Time-specified Bottom", "Block Averaging" and "Time Averaging" in the "Operation Mode" window only.
For other operation modes, "Display Mode" setting is invalid.
<Setting Range>
Normal Disp.
Hold Disp.
<How to operate>
1) Press the
window.
2) Press the
window.
3) Select and press the target key and press the
the setting value.
The peak (bottom) value is always updated and displayed in response to changes of the input
in the detecting block. The peak (bottom) value is held and displayed in the holding block.
The measured value immediately after turning ON the holding command is held and displayed
in the delay time and detecting block. The peak (bottom) value in the detecting block is
displayed when entering the holding block.
key on the "Measure Mode Setting (1/2)"
key on the "Measure Mode Setting (2/2)"
key to register
69