KYOWA WGA-910A Series Instruction Manual page 136

(2) Transmission Mode
Sets the transmission mode of the communication such as the measured value, sending method of the status,
operation by the command, etc.
<Setting Range>
Repeat Output
Output at Hold
Tx and Rx
<How to operate>
1) Press the
2) Press the target key and
設定
Continuously outputs the measured value and status (such as the HH comparator is ON, etc).
Outputs the measured value and status once during the holding time.
Sends and receives the data with the control command.
key on the "Com. Setting" window.
key to register the target value.
132
Com.Setting
Return
The communication speed of RS-
Communication Speed
232C and RS-485 is set.
9600bps
The transmission mode of com-
Transmission Mode
munication such as the oper-
ation by command is set.
Repeat.Output
It is only applied to RS-485.
Device ID
The ID of WGA-910A is set.
1
Transmission Mode
Return
Now
New Tx and Rx
Repeat.Output
The indicated value and status
Repeat.Output
are repeatedly outputted.
The indicated value and status
Output at Hold
are outputted only once at
holding.
Transmission and receiving are
Tx and Rx
conducted by control command.
Push the target key and 'Register'key.
Measure
Measure
Register