KYOWA WGA-910A Series Instruction Manual page 87

(3) Single Mode
Press the
910A in the trigger condition waiting mode.
After that, the WGA-910A starts displaying the waveform when the measured value satisfies the trigger
condition.
After displaying the waveform to the end of the X- axis for one time, the WGA-910A stops loading the
waveform and holds it.
Press the
trigger condition waiting mode.
6-4-4. Passed Level (Trigger Level)
Sets a passed level of the measured value as the trigger condition.
The
<Setting Range>
-99999 to 99999 (count)
<How to operate>
1) Press the
window.
2) Input a setting value with the numeric keyboard and press the
key for registering.
key or turn ON and OFF (MIN interval: 1 ms) the "Waveform Command" to set the WGA-
key again or turn ON and OFF the "Waveform Command" to set the WGA-910A in the
key is invalid and displayed in gray if the "Auto Mode" is selected.
key on the "Wave Display Setting (1/2)"
83
Wave Display Setting
Return
The end point of X-axis(time)
X-axis Setting
is set.
10.0sec
The start and end point of Y-
Y-axis Setting
axis are set.
1000.00kN
The mode to start the wave
Start Mode of Wave
display is set.
Auto Mode
The level that measured value
Passed Level
passes for satisfying trigger
condition is set.
0.00kN
Next
Measure
1 / 2