KYOWA WGA-910A Series Instruction Manual page 32

3-4. SD Card
・Capable of updating a setting value of the WGA-910A by reading the setting value that is saved in the SD card.
・Capable of saving the setting value of the WGA-910A in the SD card.
・Capable of saving a recorded waveform in the SD card by pressing the Start key on the "Waveform" window.
NOTE 1
Capacity of the SDHC card corresponding to the WGA-910A is up to "32 GB."
Note that the WGA-910A is does not support the SDXC standard SD card 64 GB or more.
Never insert the SDXC card 64 GB or more.
NOTE 2
Due to the SD speed class or various files saved in the SD card, the loading/writing speed of the SD card
may decrease.
The SD card may take a longer time to write the waveform data.
The recommended SD card is as follows.
Model: TS32GSDHC10
Capacity: 32 GB
Manufacture: Transcend
■ Inserting SD card
1) Pull the SD cap.
2) Insert the SD card (notch on right) as the
right figure.
3) Push the SD card until it clicks.
4) Close the SD cap.
NOTE
Note that after inserting the SD card, the measured value cannot be updated (the display value does not
vary even if the input changes) and the key operation cannot be performed for approx. 2 seconds due to
the process.
■ Removing SD card
1) Check that the SD card is not conducting
procession such as reading, saving a setting
value, etc.
2) Pull the SD card.
3) Push the SD card until it clicks and it comes
out little.
4) Pull out the SD card for removing and close
the SD cap.
28