KYOWA WGA-910A Series Instruction Manual page 48

NOTE
"TEDS Error" window blinks when the TEDS information cannot read correctly or TEDS information
value is out of specifications.
After stopping the reading of the TEDS information, the "TEDS Error" window blinks approx. 3 seconds.
After that, the current calibration value is displayed.
At this time, the calibration value is not updated.
MEMO
The "TEDS Calibration" window blinks after the following settings or conducting the following operations
during the setting or during the setting.
<Setting>
Set "Cnt. Input", "Power On", "Command" to "Allow" in the "TEDS Reading Operation" window.
<Operation>
・TEDS command of the control input is turned ON.
・Receives a communication command (EID) that executes the automatic sensitivity registering
calibration with the TEDS.
・After turning ON the power again.
Blinks
44
TEDS Cali-
Conducting TEDS
Calibration
bration
Calibration is conducted with
Calibration
sensor by 'Manual Input','TEDS
Auto'or'TEDS Part'Cal.
'Smoothing','Additional Value'
Input Setting
and 'Zero Compensation'are set
The sensor output is monitored
'Comparison Set'and 'Measure
Meas.Cond.Setting
Mode Set'are set as measure-
ment condition.
The necessary setting to dis-
Wave Display Setting
play the wave such as 'X-axis'
and 'Y-axis'are set.
Next
Measure
1 / 2