KYOWA WGA-910A Series Instruction Manual page 15

2-1-3. Measuring Window (Waveform for other than the [Block Peak-Bottom] and [Time Peak-Bottom])
1)
2)
3)
4)
5)
6)
7)
1) Cursor ON key
2) Switch key
3) Measured value
4) Y axis end point
5) Y-axis key
6) Y axis start point
7) RECORD key
8) Wave Clear key
9) Set key
10) Start key/Stop key
11) X axis end point
12) X-axis key
Switch Cursor ON
300.00
kN
Y-axis
-200.00
0.0
RECORD X-axis
The "Cursor" window appears to display a cursor.
Display changes in order from "Number" - "Zoom in number" - "Waveform"
by pressing the Switch key.
Displays a measured value with unit.
Displays the end point of the Y-axis that is set in the "Y-axis setting" of the
"Waveform display setting."
Opens the "Y-axis setting" window of the "Waveform display setting."
Displays the start point of the Y-axis that is set in the "Y-axis setting" of the
"Waveform display setting."
Starts recording waveform data while displaying waveforms.
After recording waveform data for 1 window, the WGA-910A saves the data in
the SD card.
Clears the current displaying waveform.
Opens the setting menu window.
Press the Start key to start the waveform displaying according to the preset
condition in the "Waveform display setting".
After pressing the Start key, it changes to Stop key.
Press the Stop key to stop the waveform display.
Displays the end point of the X-axis that is set in the "X-axis setting" of the
"Waveform display setting."
Opens the "X-axis setting" window of the "Waveform display setting."
The X-axis key is displayed in gray and key operation is invalid during
displaying the waveform.
The key operation becomes valid before displaying the waveform or after
clearing it.
Wave Clear Set
kN
10.0
S
Start
11
8)
9)
10)
11)
12)