KYOWA WGA-910A Series Instruction Manual page 13

2. CONTROLS AND FUNCTIONS
2-1. FRONT PANEL
2-1-1. Measuring Window (Number)
1)
2)
3)
4)
5)
6)
7)
1) Hold key
2) Switch key
3) [Detecting] lamp
[Holding] lamp
4) Comparator status lamp
5) Measured value
6) Compared value setting key
7) Power LED
8) ZERO key
9) Set key
10) Measuring condition No.
11) Operation mode
12) Compared value
13) SD cap
Switch Hold
LL LO
Detecting
Holding
999.99
HH
- 150.00
LO
Manually starts a detection and holding.
Display changes in order from "Number" - "Zoom in number" - "Waveform"
by pressing the key.
[Detecting] lamp lights up in white during detection and [Holding] lamp
lights up in white during holding respectively.
When turning ON the comparator outputs, the [HH] and [HI] light up in red,
OK lights up in white, and [LO] and [LL] lights up in yellow.
Displays a measured value with unit.
Displays the "Compared value" setting window of comparator.
Lights up in green when the power is ON.
Lights up in orange while updating the firmware.
Conducts digital zero to set the display of the measured value to 0 (or
additional value).
Displays the setting menu window.
Displays the current measuring condition setting No.
Displays "operation mode" of "measuring function."
Displays "Compared value" of comparators.
Pull the rubber SD cap and insert a SD card to a slot.
Zero Set
OK HI HH
Measure 1
Time Peak
kN
500.00
HI
- 999.99
LL
9
8)
9)
10)
11)
12)
13)