KYOWA WGA-910A Series Instruction Manual page 95

(2) Channel Check
Checks the operation related to the sensor input.
Press the
When an error occurs, the WGA-910A turns ON the control output "Abnormal channel."
<Setting Range>
Bridge Volt.: Checks that the measured value of the excitation voltage (bridge voltage) is within ±10% of
10 V or 2V.
Input Over: Checks that the sensor output is within the input range.
Display Over: Checks that the measured value is within ±99999.
<How to operate>
1) Press the
2) Press the
3) The result is displayed after a short time.
Only the "Display Over" is displaying Error in the right
window.
key to start the channel check. The result is displayed after a short time.
key on the "Self-Check" window.
key to start the channel check.
91